53 mm Press And Seal - Pressure Sensitive PS Foam Cap Liners - 100 Pack

Description

53 mm
Press & Seal (pressure sensitive) Cap Liners PS Foam-based - Tamper Evident -
Made in the USA -
Low Price, Fast & Free
Shipping
100 pack
Industry standard,
Best Quality,
Foam-based Press And Seal (P&S) Cap Liners!
Having manufactured from USA, we receive our liners straight out of the USA factory.
Meets all industry performance requirements.
Why choose P&S cap liners:
….most inexpensive choices to provide
tamper evident
seals in addition to fulfilling below requirements:
Seal to prevent product contamination and thus preserve product freshness & integrity
Seal to prevent liquid & dry products from leak & spill
From product perspective for sealing containers having dry or powder products – dry foods (ex. mixed nuts), dry pharmaceuticals (ex. vitamins), viscous liquids & pastes (ex. honey products), travel liquids, and cosmetic products.
From container/closures perspective, for sealing plastic & glass bottles/ jars, and with lined or unlined caps/closures.
Our press and seal liners come with “Sealed for Your Protection” red ink print on top…helps to authenticate your product after sealing.
Note:
When you plan to use our P&S liner against liquids, it is recommended that you sample them before using.
Finding the right fit:
....this
liner disc is cut into fit in a
53
mm size cap/closure, so its actual size is slightly less than
53
mm
(-1 mm or so). Further
53
mm liner disc is designed to
provide a complete seal for the following bottle/jar neck finishes:
53
/400 (1 thread turn),
53
/410 (1.5 thread turns),
53
/415 (2 thread turns, tall “H” dimension),
53
/425 (2 thread turns, narrow threads),
and
53
/430 (Buttress finish).
So, if you measure the neck outside diameter, for example with
53
/400 neck finish bottle/jar, you will find that it is less than
53
mm. It is to make sure that when
53
mm cap liner seals the bottle top, it fully covers the bottle top with tiny bit in excess.
In other words, when you measure the bottle outside diameter, and then you add 1-2 mm to that size, and if the total
comes out to be close to
53
mm, then you order
53
mm cap liner for your application.
It will work for you!
The bottom line aspect is that these cap liners are designed in a way to fully cover the bottle/jar landing/sealing area and to provide a complete seal when it is properly applied with sufficient pressure.
How to apply the P&S cap liner:
1. Clean the bottle/jar landing area with cloth
2. Position it inside the cap (preferred way) or position it over the landing area on top of the bottle/jar
3. Apply the cap to bottle/jar top with some tight pressure/torque. No heat required!
Note: With the application pressure/torque, keep it tight for at least 30 min. After 30 min, a good seal is generated between the liner and bottle. Excellent results are achieved with better seals in certain applications if you keep it tight for 24 hour.